Resistance measurements on wafers and bricks

With MDPmap and MDPingot it is possible to measure the resistivity of wafers or bricks with a high accuracy and a resolution of 1 mm via eddy current measurements. The Eddy current sensor setup has a very good long-term stability, due to a distance correlated internal calibration matrix. Hence, with every resistivity map a geometry map of the surface flatness is measured. The resistivity can be measured simultaneously with the minority carrier lifetime and photoconductivity maps. In case of wafer measurements, the thickness of the sample has to be given by the user.

• Step width ≥ 1mm

• Edge exclusion 12 mm

• Resistivity wafer thickness range 150 ...250 µm

• Resistivity range can be specified

• Default setting: 0.5 to 5 Ohm cm

• Accuracy: < 5 %

• Repeatability: < 1 % (range of 0.5 until 3 Ohm cm)

It is possible to map the sheet resistance of the emitter, in order to investigate the homogeneity of the emitter diffusion. The resistivity of the base has to be given by the user.

Sheet resistance measurement with range 0.1-200 Ohm/sq

Accuracy at standard sample size,

• 0.1 - 10 Ohm/sq: < 3 % accuracy

• 10 - 100 Ohm/sq: < 4 % accuracy

• 100 – 200 Ohm/sq: < 5 % accuracy

Figure 1 to 3 show examples of resistivity maps measured on mc-Si wafers and bricks.